GJ6A-28-170B

A stabilizer link (also called a sway bar end link) is the short connecting rod between the anti-roll bar and the strut or control arm — it transfers body-roll forces from one side of the suspension to the bar, which then loads the opposite wheel and resists roll. Every modern vehicle with an anti-roll bar has stabilizer links, typically two per axle.

Also known as: sway bar link, sway bar end link, anti-roll bar link, drop link.

How it works

Roll resistance

When the vehicle leans into a corner, the outside suspension compresses. The stabilizer link transfers that compression to the anti-roll bar, which twists and pushes down on the inside-suspension link — sharing the load between both wheels and reducing body roll.

Independent travel preservation

The link's ball joints (one at each end) allow the bar to twist freely while the suspension still articulates independently — without them, the suspension would bind.

Structure and construction

A short steel or aluminum rod with a sealed ball joint at each end (or rubber bushings on older designs). Length is critical — even a few millimeters off changes the bar's pre-load and alters handling balance.

Common failure symptoms

• Rattling from the front suspension. A loose, metallic rattle over rough surfaces, most audible at low speed. Usually the first symptom of a worn link ball joint.
• Excessive body roll. A snapped link disconnects the anti-roll bar entirely; the vehicle leans noticeably more in corners.
• Loose, "floaty" handling. The vehicle responds slowly to steering input and feels unstable at highway speed.

Common questions about Stabilizer Links