| Brand | Car Name | Model | Year | Position |
|---|---|---|---|---|
| Nissan | Datsun Pick Up 4wd | — | 1985- | OUT R/L |
| Nissan | Terrano | — | 1986- | OUT R/L |
A tie rod end is the outermost ball-jointed connection in the steering linkage — the wear part that transfers steering motion from the rack (or center link) to the steering knuckle at each front wheel. Every steering system, modern rack-and-pinion or older parallelogram, has tie rod ends; they are one of the highest-volume steering wear items in the global aftermarket.
Also known as: outer tie rod end, steering tie rod end, track rod end (UK/EU), TRE.
The steering rack moves left-right in a straight line. The tie rod end converts that lateral push into the angular motion that swings the steering knuckle around its pivot, turning the wheel.
The threaded sleeve between the inner and outer tie rod is the front-toe adjuster — turning it lengthens or shortens the linkage, opening or closing toe. All wheel-alignment toe corrections happen at this joint.
The ball joint inside the tie rod end allows the steering knuckle to rise and fall with the suspension while still transmitting steering input — without it, the steering would bind through bumps.
A forged steel housing with an internal ball stud, sealed greased bearing surface and rubber/polyurethane dust boot. The stud has a tapered shaft with a castellated nut and cotter pin (or a self-locking nut) to lock it into the steering knuckle. Thread direction on the rod sleeve is opposite between left and right sides on most vehicles, allowing toe adjustment without disconnecting the joint.
How often should tie rod ends be replaced?
There is no fixed interval — they are replaced when worn. Typical life is 100,000–150,000 km on paved roads, less on rough or salted roads. Inspect every service: with the wheel off the ground, a good joint has zero perceptible play when the tire is rocked side-to-side.
Can I drive with a worn tie rod end?
Short distances at low speed, yes. A tie rod end that fails completely will result in total loss of steering on that wheel — the wheel will flop free and the vehicle will be undrivable. Replace promptly once a clunk or visible play is detected.
Do tie rod ends always come in pairs?
Not necessarily — left and right are usually sold individually and use opposite-thread rods. However, replacing both sides at the same time is best practice once one shows wear, since the second side will typically fail within a similar timeframe.
Is wheel alignment required after replacement?
Yes. The toe setting is established at the tie-rod sleeve, and any disassembly of the joint changes it. Drive directly to an alignment rack after replacement.
Нет. Это аналог производства SLOOP, изготовленный по спецификациям OEM. Оригинальный номер SLSE-0164 используется исключительно для идентификации применяемости по принципу nominative fair use — он не подразумевает лицензирования, одобрения или аффилиации с каким-либо автопроизводителем. За оригинальными запчастями обращайтесь к официальному дилеру.
Соответствие форме, посадке и функции подтверждено испытаниями по спецификации OEM. Протоколы испытания материала и размерные чертежи прилагаются к каждому коммерческому предложению. Для крупных партий мы изготавливаем предсерийный образец для проверки вашей службой ОТК до запуска основного тиража.
Система менеджмента качества по ISO 9001:2015, а также соответствие требованиям REACH / RoHS для поставок в ЕС. Протоколы испытания материала и документация PPAP предоставляются по запросу для покупателей первого уровня. Сертификаты прилагаются к первой отгрузке каждого нового артикула.
Бесплатные образцы не высылаются. Первый заказ одновременно является квалификационной партией. Мы удерживаем производственный тираж до тех пор, пока вы не подтвердите визуальную и размерную приёмку первого ящика. Если что-то не соответствует спецификации — переделываем за наш счёт.
100% T/T (банковский перевод) до запуска производства. Только USD. Банковские реквизиты и проформа-инвойс высылаются после согласования коммерческого предложения. Кредитные условия и аккредитив на первый заказ не предоставляются.
Позиции в наличии — отгрузка в течение 15–30 days с момента подтверждения оплаты. Производство под заказ: 90–120 days с момента подтверждения оплаты. Авиадоставка (DHL / FedEx, «от двери до двери» с отслеживанием) — 5–7 дней. Морской фрахт — 25–40 дней в зависимости от порта назначения. Возможна отгрузка на условиях FOB Тайвань или DDP ваш склад.
Загрузите полный список запчастей на странице запроса коммерческого предложения. Мы подберём всё, что есть в нашем ассортименте, а остальное внесём в план производства. Накопленные запросы напрямую формируют состав следующей производственной серии.